FlightClub Proton

Nieuw product

Flightclub Proton Frame.

Meer details

€ 70,00


FlightClub PROton Race Drone Frame designed from the ground up to be a race drone frame, the FlightClub PROton can adapt to any situation.

At the heart of the FlightClub PROton is the CNC Nucleus plate. It allows PROton to be configured into a total of 10 different frames. The Nucleus plate is a CNC milled 7075 aluminum plate that lets the PROton rock either a canopy or skeleton (standoff) mode. The Nucleus plate features threaded holes for the replaceable arms. This eliminates the need for M3 nuts or capture nuts that either strip or are a hassle to swap arms.


Borrowing a design feature from it’s brother Tokio, the Nucleus plate will have Butter Mounts. Butter Mount is an innovative way to mount the flight controller stack using custom silicon injection molded grommets that virtually eliminates vibrations.


PROton Highlights:

Nucleus Plate CNC’d out of 7075 Aluminum
Can wear a canopy or skeleton for people who like building with standoffs
Threaded holes in the Nucleus plate for easy arm replacements. No nuts or pliers needed!
Has 30.5×30.5mm mount holes
Butter Mount for a vibration free flight controller stack
Chamfered edges on the bottom carbon fiber plate
Countersunk holes on the bottom of the frame for a completely flat bottom
Camera protection in both Canopy or Skeleton mode
Camera Angle approximately: Skeleton 0-80 degrees


Base PROton will include the following:

1 – Nucleus CNC Aluminum Plate
1 – 3mm Chamfered, countersunk bottom CF Plate
4 – 4mm Arms
12 – Silicon injection molded Butter Mounts
4 – M3x20 Button head screw (for flight controller stack)
9 – M3x10 Flat Head Hex screws
4 – M3 Nylon nuts
1 – 1MM CF VTX Plate
2 – Antenna Tubes
2 – Antenna caps
1 – FlightClub Velcro Strap
1 – Sticky Battery pad


Skeleton Mode will include the Base PROton above plus:

1 – 2mm CF top plate

4 – 25mm Black Standoffs
1 – TPU Camera mount adapter for Micro Camera
1 – TPU VTX / RX antenna mount
8 – M3x8 button head hex screws


Canopy Mode will include the Base PROton above plus:

TPU Printed Canopy
2 – M3x10 Hex Standoff
2 – M3 Washer
2 – M3x5 Button head hex screw
2 – M3x8 Button head hex screw
Different height Standoffs can be used for higher or lower stacks.


FPV Flightclub PROton Frame Overview:



Related Products